Investigation of Mechanical Behavior of Al2O3 Coating on AISI - 316 Steel

Authors

  • S. Jeevabharathi Assistant Professor, Department of Mechanical Engineering, BIST, BIHER, Bharath Institute of Higher Education & Research, Selaiyur, Chennai. Author

DOI:

https://doi.org/10.61841/hkw7pm04

Keywords:

Thermal Spray Coating, Alumina, Austenitic Steel, Corrosion, Salt Spray Test, Rockwell Hardness Test

Abstract

 In this work the micro structural description and mechanical properties of alumina coated AISI 316 austenitic steel were examined. The microstructure of both coated and un coated specimens of AISI 316 austenitic steel are captured and studied. The corrosion resistance of the materiel is found out using salt spray test and the hardness of the specimen has been found by using Rockwell hardness principle and equipment. Alumina has an excellent ability to hinder the inward diffusion of oxygen and especially above 1000 degrees centigrade. Alumina is the most effective oxide against environmental attacks. When high temperature metallic coating is exposed to an oxygen containing environment, a protective oxide scale is expected to form on the surface of the coating to slow down or even avoid the depletion of alloying elements by hindering the diffusion of metal ions and oxygen through the oxide scale 

Downloads

Download data is not yet available.

References

[1] Evaluation of arc sprayed coatings for erosion protection of tubes in atmospheric fluidised bed combustion

(AFBC) boiler was presented by Krishnarao Venugopal, Manish Agrawal.

[2] Hot Corrosion & Erosion Problems in Coal Based Power Plants in India and Possible Solutions-A Review

were presented by Vikas Chawlaa, Amita Chawlab, D. Puric, S. Prakashc, Prema G. Gurbuxanid and Buta

Singh Sidhue

[3] Particle characterization for angularity and the effects of particle size and angularity on erosion in a

fluidized bed environment was presented by S.L. Palasamudram a, S. Bahadur b

[4] Erosion-Corrosion behavior of Ni-based super alloy Superni-75 in the real service environment of the boiler

was presented by T S Sidhu1, S Prakash2, R D Agrawal2 and Ramesh Bhagat.

[5] High Temperature Degradation by Erosion-Corrosion in Bubbling Fluidized Bed Combustors was published

by Peggy Houa, Stuart Macadam, Yan Niuc, John Stringerd.

[6] Corrosion fatigue cracking of tube coils in an actifier column catalytic cracker was published by Xuan Shia,

Yaowu Shib.

[7] Numerical modeling of brown coal combustion in a tangentially-fired furnace. Zhao feng tian, peter j. Witt,

m. Phillip schwarz and William yang.

[1] MANETs. Bonfring International Journal of Industrial Engineering and Management Science, 7(1), 29-31.

[8] Morad, M.J.A., Talebiyan, S.R., & Pakniyat, E. (2015). Design of New Full Swing Low-Power and HighPerformance Full Adder for Low-Voltage Designs. International Academic Journal of Science and

Engineering, 2(4), 29-38.

[9] Fouladgar, N., & Lotfi, S. (2015). A Brief Review of Solving Dynamic Optimization Problems.

International Academic Journal of Science and Engineering, 2(6), 26-33.

[10] Grace, M.C., Shanmathi, S., & Prema, S. (2016). Design ofRFID based Mobile Robotand its

Implementationin Pharmacy Dispensing System. International Journal of System Design and Information

Processing, 3(1), 6-12.

[2] Karuppasamy, S., Dr.Singaravel, G., & Kaveen, P. (2018). Scrum Investigation Analysis for Android

Application. Bonfring International Journal of Networking Technologies and Applications, 5(1), 12-16.

[11] Cowl, D., and Sim, S. (2017). A Complete Introduction to the Swarm Robots and its Applications. Bonfring

International Journal of Power Systems and Integrated Circuits, 7(2), 6-12.

[12] Dr.Prabakaran, S. (2018). Farmers Resource Make Use of Technical Efficiency - Organic and Modern

Agriculture. Journal of Computational Information Systems, 14(5), 85 - 91.

[13] Dr.Murugamani, C., & Dr.Berin Jones, C. (2018). A Novel Approach to Secure and Encrypt Data

Deduplication in Big Data. Journal of Computational Information Systems, 14(5), 92 - 99.

[14] RavindraBabu, B. (2018). Resource Provision for Software as a Service (SaaS) inCloud Computing

Platform.. Journal of Computational Information Systems, 14(5), 100 - 111.

[15] Sowmyadevi, D. (2018). Secured and Freshness Ensured Provenance Sharing Scheme for the

Heterogeneous Wireless Sensor Network. Journal of Computational Information Systems, 14(6), 1 - 17.

Downloads

Published

31.08.2019

How to Cite

Investigation of Mechanical Behavior of Al2O3 Coating on AISI - 316 Steel. (2019). International Journal of Psychosocial Rehabilitation, 23(3), 202-207. https://doi.org/10.61841/hkw7pm04